20' Shipping Container Banner Frame

Everything* you need, to attach a 20' banner to the side of your shipping container. This creates a 20’x 8’ banner frame with two vertical supports in the middle allowing you to attach your banner along the entire long side of your 20’ shipping container. This can also be adapted to suit a 16’ container, or even a 40’ container.   INSTRUCTIONS 1. Start by installing a Domino Clamp in each of the four corner castings on the long face of your shipping container. Follow our detailed installation instructions if you're unfamiliar with the technique. 2. Use two M12x30 set screws and washers to attach a horizontal perpendicular tube clamp to each of the Domino Clamps. Use the top row of holes in the top Domino Clamps and the bottom row of holes in the bottom Domino Clamps for this. 3. If you plan to anchor the middle of the frame to the floor (optional), slide the two double lugged floor mounting brackets onto the bottom length of steel tube and position where required before the next step. 4. At ground level, put the verticals and horizontal sections of the frame together using the four lengths of steel tube and the 3-way tube clamps. 5. Insert a spigot of steel tube (14cm or more) into the remaining hole in each of the four 3-way elbow clamps. 6. Now, with two extra people to help, tilt the frame up and insert the short spigots into the tube clamps attached to the Domino Clamps. 7. Have two people hold the frame in position while you do up the grub screws on all the tube clamps with the 8mm hex key, making sure everything is nice and tight. 8. Attach the banner to the frame   YOU WILL ALSO NEED: ● Steel scaffolding tube (48.3mm diameter / 1.5” NPS Pipe) Cut to: ○ (x4) 2.45m (verticals) ○ (x2) 5.8m (horizontals) ○ (x4) 14cm (spigots) Please note that these measurements might change slightly depending on your container, what it is sat on, and also how you arrange the tubes inside the tube clamps. Please double check your measurements as you go. (Remember: “measure twice, cut once!”) ● 10mm & 8mm Hex Key ● Adjustable wrench/spanner ● Banner and method for attaching the banner to the frame. (This is often done with rope, or bungees. Ask your banner supplier what options they offer) ● (Optional) (x4) screws, expanding bolts, or other suitable fixing to secure the floor mounting brackets to the surface your container is sat on.

Dimensions:

Weight: